Next time I won’t bother with the thermal fuse, though it is easy to access and inexpensive $8.59 (at AppliancePartsPros. Almost as loud as the "click" you hear when you clip your finger nails. The dryer will not start if the door latch is malfunctioning. The new one made a distinct "clicking" sound. When I rec’d the door pressure switch I immediately noticed a difference in the sound it made when I pressed the buton. Parts were in stock and they had reasonable shipping costs.) A blown fuse at the thermal unit, an error with the heater relay on the control board, or issues with the pulley system are likely reasons for this problem. If the switch does not have continuity, replace it. Use a multimeter to test the start switch for continuity. If the dryer does not respond or make any noise, the start switch could be at fault. I’ve only ordered from them twice, first time was the thermal fuse, and was very satified. If the dryer hums but does not start, the start switch is not at fault. Step Five: Put the front panel back on and plug the dryer back in. Step Four: Reconnect the wires to the timer. Step Three: If they do not have a spark, replace the timer. Step Two: Disconnect and check the wires with the ohmmeter. The part cost me $18.46 + shipping & handling at (I don’t get anything from them. Step One: Unplug the dryer and remove the front panel. One site mentioned the door pressure switch. Everything I read mentioned the "thermal fuse." I changed that, no luck. So, what’s a "6e"? Again, I went to the internet. Somewhere I read to "run the diagnostic test." It is as follows: Within 5 seconds, press the button that says "more time" then "less time" then "more time" then "less time." Wait for a second or two then it read "6e." Then remove the top panel screws to show the section of the control panel Press down the tabs of the control panel to release the outer cover Disconnect the cables that hold the panel in place and set the panel aside Next, unscrew the circuit board bracket and remove it. All the lights came on but when I pressed the start button it just beeped several times and wouldn’t start. Power down the duet dryer and disconnect it from the power source. Whirpool Duet front load electric dryer error code 6e
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |